Cement Project

  Manufacturing Process 1. Crushing & Proportioning:
Limestone rock is the principal raw material, the first step after quarrying in the processes is the primary crushing. Mountains of rock are fed through crushers capable of handling pieces as large as an oil drum. The first crushing reduces the rock to a maximum size of about 15 cm (6 po). The rock then goes to secondary crushers or hammer mills for reduction to about 7.5 cm or smaller. 2. Raw milling & Blending:
The next step in the process is to grind the above particles to a size of 90 microns or less which is done in a raw mill, a closed circuit ball mill equipped with high efficiency separator. After achieving the 90 microns size the fine grinded material also known as raw meal is sent to the continuous blending silos (CFC) for homogenization & extracted by means of load cell hopper for the next step which is feeding to the kiln pre heaters. 3. Pyro processing:
The raw material is heated to exceeding 1,450 ¡ãC (2,700 degrees F) in huge cylindrical steel rotary kilns lined with special firebrick. Kilns are frequently as much as 3.7 M (12 pi) in diameter, large enough to accommodate an automobile and longer in many instances than the height of a 40-story building. Kilns are mounted with the axis inclined slightly from the horizontal. The finely ground raw material or the slurry is fed into the higher end. At the lower end is a roaring blast of flame, produced by precisely controlled burning of powdered coal, oil or gas under forced draft. 4. Burning and cooling:
As the material moves through the kiln, certain elements are driven off in the form of gases. The remaining elements unite to form a new substance with new physical and chemical characteristics. The new substance, called clinker, is formed in pieces about the size of marbles. Clinker is discharged red-hot from the lower end of the kiln and generally is brought down to handling temperature in various types of coolers. The heated air from the coolers is returned to the kilns, a process that saves fuel and increases burning efficiency. 5. Cement milling, Storage & Packing:
Portland cement, the basic ingredient of concrete, is a closely controlled chemical combination of calcium, silicon, aluminum, iron and small amounts of other ingredients to which gypsum is added in the final grinding process to regulate the setting time of the concrete. Lime and silica make up about 85% of the mass. Common among the materials used in its manufacture are limestone, shells, and chalk or marl combined with shale, clay, slate or blast furnace slag, silica sand, and iron ore. Main equipments:
Milling equipments
Calcining apparatuses
Calcining apparatuses of quickened lime
Rotary kiln
FU chain conveyor
NE hoisting machine
TH, TCH hoisting machine
rubber belt conveyer
BFRS dust arrester
PPCS32-64 pulse bag dust arrester
hammer crusher
PFC counterattack hammer crusher
counterattack crusher
jaw crush